Cue the artist
Put 10 MIN, LAST TRACK, WRAP IT UP or HARD STOP across the artist's monitor with one press, and clear it when it's done. The countdown also changes colour by itself near the end of every set.
On this page
Before you start
- Run show is open on the stage you want to cue.
- The stage's artist monitor is open. See Artist monitors and screen links.
In Run show, pick the stage from the stage tabs.
In the Cue the artist card, press 10 MIN, LAST TRACK, WRAP IT UP or HARD STOP. The cue shows across the top of the artist's monitor at once.
Check the line under the buttons: it reads On screen: and the cue, or No cue on screen.
Press Clear on that line to take the cue off. Sending another cue replaces the one showing.
From the keyboard, press 1 to 4 for the four cues and C to clear. See Keyboard, MIDI and Stream Deck.
In Setclock Admin, open the show, then pick the stage tab.
In the controls at the bottom, tap 10 MIN, LAST TRACK, WRAP IT UP or HARD STOP. The button turns amber and reads AGAIN.
Tap it again within 4 seconds to send. The monitor shows the cue.
To clear it, tap the × next to the cues, then tap again. Clear cue: in the Message the artist card does the same.
What the artist sees
- 10 MIN, LAST TRACK and WRAP IT UP show as an amber banner above the countdown; HARD STOP shows in red.
- A cue stays until you clear it or send another one. Custom messages can clear themselves; see Messages, flash and blackout.
- Preset cues show in each screen's language. Typed messages show exactly as written. See Screen language.
- Blackout hides cues. An all-stage alert or a stage emergency takes over the screen instead.
Automatic wrap-up colours
You don't need to cue every set. The countdown turns the warning colour when Warning starts (5 minutes left by default), the final colour at Final warning starts (1 minute), and the over-time colour after 00:00. Run show shows the phase beside the countdown: 10 min left, Wrap up, Final minute, Over time.
Set the times and colours in Settings › Monitor › Wrap-up colours, with Flash the monitor at final warning and Subtly pulse the countdown in the final warning. They apply to every set on every stage of the show. See Monitor look and layouts.
I pressed a cue and the monitor didn't change.
Check the line under the buttons says On screen:. If it does, the monitor may be offline, in blackout or showing an emergency. See A screen is frozen or out of sync.
The cue won't go away.
Preset cues stay until cleared. Press Clear, or C on the keyboard.
On iPhone nothing happens when I tap a cue.
Every Run show control in Setclock Admin needs a second tap within 4 seconds. If the buttons are greyed out, another device has control; see One controller at a time.